![printshop cuts and chops final print printshop cuts and chops final print](https://i0.wp.com/www.foodtasticmom.com/wp-content/uploads/2014/06/grilledpork4.jpg)
#Printshop cuts and chops final print software#
The software allows you to import an existing 3D model and perform a number of operations on it.
![printshop cuts and chops final print printshop cuts and chops final print](https://bloximages.chicago2.vip.townnews.com/hmbreview.com/content/tncms/assets/v3/editorial/c/3c/c3ca333c-a065-11e1-aa4b-001a4bcf887a/4fb56c154159f.image.jpg)
There is a software solution for this dilemma, and it’s called LuBan.ĭeveloped by researchers at MIT and Singapore University of Technology and Design, this tool offers a number of very useful and practical features that can transform a 3D model, including automatically splitting it up into print-sized chunks. I know what you are thinking now: “If there’s more than two or three pieces, I give up!” If you have, say, 50 pieces printed, how do you know which one is which? In what order do you assemble them? There’s yet another challenge: keeping track of the parts. Even worse, where do you put the pegs if a piece has more than two sides joining others? Or four? If you do this wrong, then you will not be able to assemble the parts! 3D printed parts to be assembled What if your large 3D print is so big that it requires dozens, or perhaps a hundred separate parts? Are you going to 3D model pegs and holes on each part? That could take a considerable amount of time. That is fairly easily done in most 3D modeling tools, but will take a few minutes to do. Then there is only one way they fit together. If you simply chop a 3D model in half, how do you know how the two pieces should be aligned when glued? The answer is to insert some holes and pegs into the two models’ designs.